#Ful lattice crystal filter design full
#Ful lattice crystal filter design series

Some additional work needs to be done on crystal neutralising and to determine the optimum L- C ratio for L1/C1 for each filter bandwidth. A ladder filter may be more appropriate for SSB and CW bandwidths as long as the crystal parameters are correctly specified.

#Ful lattice crystal filter design series

This filter is slightly off of the normal Heath IF of 3.395MHz but does prove that the design approach works.ДЄ third filter was constructed using pairs of crystals at 3.3954MHz and 3.3964MHz (1KHz spacing) and this produced a poor quality passband characteristic, probably because the internal series and parallel resonant frequencies were not optimised for the narrower passband. The ultimate stopband was about - 65dB without any neutralising or screening. Spurious responses were noted some 50KHz above the passband at about - 50dB. Parallel resonant frequency of crystal without any external external added parallel capacitanceДЄ similar format filter has also been constructed using crystals at 3.3936MHz and 3.3954MHz which resulted in a - 3dB bandwidth of 2.45KHz, a centre frequency of 3.39388Mhz, - 60dB bandwidth of 9.85KHz and an impedance of 870ohms. More advanvced readers might like to consult 'Crystal Filters - Design, Manufacture and Application' by Robert G Kinsman, ISBN 0- 471- 88478- 2, published 1987 by Wiley. 'Single Sideband for the Radio Amateur' (5th Edition 1970) by the ARRL has a more detailed description of the design of lattice crystal filters.

#Ful lattice crystal filter design full

Readers are referred to the ARRL or RSGB Handbooks for more information on the design and construction of half and full lattice filters. A high Q conventional tuned circuit would also help. It should be possible to significantly improve the performance of this filter using more carefully specified crystals and adding another half or full section. This is not surprising as these crystals were intended for use in oscillators where the spurious response requirements are less stringent than for filters.

Problems with several spurious responses at about 3.5MHz were noted.

The ultimate stopband attenuation of the filter is about - 63dB but this can be improved to better than - 70dB by neutralising the crystals with very small value capacitors - typically 0.47 - 0.68pF. The shape and position of the top part of the passband is significantly dependant on the tuning and respective values of L1 and C1. Final value will depend on the winding of L1 and circuit layout. This filter was constructed to see what was possible with standard, off the shelf crystals from Heathkit SB Line units (manufactured during the late 1960s).ДЈ.3936MHz HC6/U Heathkit SB line CIO crystalДЈ.3964MHz HC6/U Heathkit SB line CIO crystalДҐ7+57t 30swg enamelled copper wire bifilar wound on an 0.5 inch diameter Micrometals grade 8 (red) dust iron toroid.Дў- 22pF trimmer in parallel with 22pf fixed silver mica or polystyrene capacitor. The rule of thumb says that the resulting filter bandwidth will be between 1.7 and 2 times the pole zero spacing. Specifically, the lower frequency crystal should have its series resonance on the LF edge of the passband and its parallel resonance at the centre of the passband and the higher frequency crystal should have its series resonance at the centre of the passband and its parallel resonance on the upper edge of the passband. Lattice filter design theory requires the internal series and parallel resonant frequencies (subtract to get the pole zero spacing) of each crystal lie at specified points on the required passband.

The above is comprised of two half lattice filters connected back to back so that only a single tuned circuit is required.